Genuine OEM replacement Blade, this item is sold individually. This Blade is used on the Lawn Tractor models shown below. Most of the Lawn Tractors listed below will use 3 of these blades. It would be a good idea to purchase 3 extra blades so when your blades on the Tractor need sharpening, you can use your extras.
Remove drive belt then remove the deck from the mower. Take the guards off, then the blade then the jack shaft housing and shaft. Install new one , don\'t forget to grease it an the others too.. Put all back together an your done.
The package that the belt is sold in has the routing of the belt right on the package. I jacked up the front of the mower, then put jack stands underneath it and blocked the rear wheels. I remove the blade nuts, then the washers and the blades. I the placed the blade adapters on the spindle, followed by the blades, the washers and tighten
... Read moreed the blade nuts.
Used jack to raise lawnmower; place lawnmower on jack stands; use a block of wood to stop lawnmower from rolling back wards off jack stands; use another block of wood to stop blades from moving around; use WD 40 to losing up bolts on old blades; grab your socket set while you wait for the WD 40 to work on the bolts; replace one blade at a
... Read more time; making sure that bolts are good and tight; lower your lawnmower, put away your equipment that you used; run your lawnmower and cut your grass.
Remove the blade nut and washer then the blade
Make sure the blade adapter is above the blade when you put the new blade on the spindle.
Place the washers on and tighten up the blade nut
Put the mower on blocks to raise the front and block the rear wheels. Make sure the mower is secure and won\'t move. Remove the blade holder nut and the washers. Remove the worn blade and blade adapter. Place the new blade adapter on the spindle, then the new blade, two washers and tighten the blade nut
Removed the deck from the mower
Took note on where the belt was positioned
Installed the new belt in the same way
Removed the blade nuts and washers then the blades
Installed the new blades on the spindles
Replaced the washers and tightened the blade nuts
Then attached the deck to the mower
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP12089870
Manufacturer Part Number: 56631E701MA
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 56631E701MA Murray Single Blade")
_WW_1.gif "Part Location Diagram of 56631E701MA Murray Single Blade")
