1. Removed the deck from the tractor by removing three cotter keys and pins (lift mechanism for raising and lowering the deck).
2. Remove blades (must secure blade with wooden block), remove spindles from deck, remove pulleys from spindles, drive out spindle shafts being careful to note placement of washers and spacers.
3. Pac
... Read moreked spindle housing with grease using a finger.
4. Install new spindle shafts and wipe away excess grease.
5. Use reverse order to complete the job.
Read less
Did you find this story helpful?
Thank you for voting!
Deck was not working, needed new pullies, belts and blades.
Scott from Orlando, Florida
7 of 7 peoplefound this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
1. Removed the old belts.
2. Removed the deck.
3. Replaced the pulleys and then the belts.
4. Reinstalled the deck.
5. Replaced the belts.
6. Tested, cut grass.
Lowered mowing deck. Replaced three belts and put on two new mowing blades. Not difficult but its is a good idea to take a picture with your cell phone of the old belts prior to removing. It is a good reference guide and many times easier than a manual. A picture is worth a thousand words !!!!!!!!!!!!!!!
Used floor jack. Jacked up riding mower. Raised deck to highest level. Used impact tool to remove blade nut and 4 spindle bolts. Lowered deck to lowest level. Removed old spindle. Install new spindle tighten 4 3/8 spindle bolts. Install blade and new spindle bolt for blade.
Lowered deck to replace worn belt and notice that pulley was bad order replacement. I really a applaud you all for having the Schematic to show the actual breakdown . This really helped in completing the task
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9105840
Manufacturer Part Number: 712-0417A
Lawn Mower
- Cc 600 Self Propelled Walk Behind Mower
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_5.gif "Part Location Diagram of 712-0417A MTD Use 712-0417a")
_WW_5.gif "Part Location Diagram of 712-0417A MTD Use 712-0417a")
