1. Remove battery and straps that the battery sits on for access to the transmission pulley,
2. Place screw driver through hole in the pulley to secure and remove the nut on top of the pulley.
3. Remove the two springs on the idler assembly to release pressure on belt.
4. You will need to loosen the two bolts on the righ
... Read moret holding the axle to the frame to get enough clearance to remove the pulley. It is not necessary to remove the bolts. Just loosen enough to slightly depress the sale.
5. Jack the tractor up to clear the right wheel.
8. Press down on the right axle and remove the transmission pulley. You only need about a 1/4 inch of additional clearance when you press on the axle.
7 Remove the transmission hub.
8 Replace transmission hub.
8 Replace the transmission pulley and put belt back in place on the pulley.
9 Replace and tighten nup on top of pulley.
10 Tighten the two bolts on right axle that were loosened for clearance and remove jack.
11 Replace two springs on iddler assembly.
12 Replace battery hanger straps and battery.
1) Removed 6 bolts hold trans and rear axle in place. (Makes it easier to get on the 9/16 flange nut.
2) Used an impact driver to remove the 9/16 flange nut. (With a normal socket or wrench the whole rear end turns).
3) Remove stripper pulley and 5/8 spline, replaced with new Spline, pulley and flange nut.
4) With b
... Read moreelt around the pulley, tighten flange nut with impact.
5) Re-install 6 bolts holding trans and rear end back in place.
6) Assemble belt on idler and tension wheel and attach spring. Complete
Lifted rear of mower. Removed battery and wheels. Removed pin from gear shift. Removed 6 bolts holding transmission. Disconnected brake from transmission. Removed transmission, and replaced the top hub/pulley. Reversed all procedures putting mower together. Runs great! (Wasn\'t my first time pulling the trans off. First time consisted of
... Read moreopening transmission up and replacing a part inside it)
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP16411637
Manufacturer Part Number: 718-04407
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
