Clutch Cable 584243501

1. Removed the cowling from top the motor.
2. Removed the gas tank
3. Removed the dash
4. Removed the old cable from the engagement lever
5. Installed the new cable to the lever
6. Reinstalled the dash, gas tank, and motor cowling
7. Connected the new cable and spring to the deck and idler pulley

Took mower deck off and replaced the worn parts. Took gas tank off and replaced the cable

1: Remove the spring and washer under the steering wheel housing and release the eyelet end of the old cable.
2: Use a pair of pliers to squeeze the tabs on the cable clip and pulling while wiggling the cable remove it.
3: Working toward the mower deck free the cable from all clips and holes. (Take mental notes or pictures if ... Read more you need to on where the cable is routed.)
4: Using the pliers squeeze the tab on the spring end of the cable as in Step 2. (It can be easier of you lower the deck all the way down first.)
5: Remove the spring end of the cable from it\'s attachment point on the pulley system.
6: Reverse the order of the steps to install your new cable. The only difference is you don\'t need the pliers, you can just push the ends in and they just snap into place.

Removed old cable and routed new cable accordingly. , Did it twice because the first replacement part failed in just two house. I suggest you start from the bottom at the mower deck and work up to the dash lever.