This flat metal washer fits onto the speed guide-selector and is available individually. Please note that more than one washer may be needed when replacing parts. It will need to be replaced if it becomes lost or broken and may require a wrench during installation. This is an OEM Toro part sourced directly from the manufacturer and used in snowthrowers.
1. Removed old deck
2. Looked up all the parts I would need by using the Internet and ordered
3. Went to the hardware store several times to get more tools
4. Everything re-assembled relatively easily.
5. Mower in working condition again and mowing nicely
Did you find this story helpful?
Thank you for voting!
bolt had broken on idler pulley and belt had fallen off
Hardest part was reaching between deck and mower frame. But was less time consuming than dropping and pulling deck out. Used pliers to unhook tension spring then removed pulleys. Similar step to replace.
The bolt that held the wheel on broke. I ordered the replacement bolt, nut & washer for my make/model lawn mower and used the wrenches to re-attach the wheel.
Did you find this story helpful?
Thank you for voting!
The bolt that attaches the whole wheel and height control cracked in two.
1. Went to your site to look at which parts had been there before they broke off and fell somewhere in the yard.
2. Ordered the parts and waited them to arrive.
3. Unscrewed the bolt-shoulder from the cutting height mechanism (a.k.a. arm pivot), allowing me to remove the wheel.
4. Slipped the new bolt that had been
... Read morecracked (screw-shoulder) into the arm pivot.
5. Re-attached the wheel.
6. Slip the spacer-wheel over the screw-shoulder.
7. Slip the screw-shoulder through the hole in the chassis.
8. Place the washer-flat on the screw-shoulder
9. Screw on the nut to the screw-shoulder.
Had to remove wheels,belt cover and blade to replace key springs, new belt and lube rear wheels after cleaning said parts.
I would never do this job as shown in tutorial and feel it\'s necessary to remove both wheels ,blade belt shroud and rear wheel holders and use new washers and bearings to give the job more/longer service.
Socket set, took out old bolt and washer out and replaced with new pulley and bolt. I then put the belt back over the idler pulley and started cutting grass for 2 hours.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 3256-24 Toro Washer-flat")
_WW_1.gif "Part Location Diagram of 3256-24 Toro Washer-flat")
