This part is priced as an individual replacement even though two may be needed. The flange ball bearing attaches to the front wheel, one on each side. It is made of metal and may require a set of pliers during replacement if this part breaks. This is a genuine Snapper replacement part that is sourced from the original manufacturer for use with rear engine rider mowers.
Since the bearing was missing, the wheel came off while mowing and the washer was bent, e-ring and cap destroyed, and obviously the bearing was not there. I hammered the washer flat with a hammer. Slid off the wheel, inserted the bearing, replaced, slid on the washer, used a plier to help snap on the e-ring and popped the cap back on wit
... Read moreh my hand. Easy and saved myself 100 bucks in labor and the trouble of taking it somewhere. Mower works great now.
Read less
Did you find this story helpful?
Thank you for voting!
Tie rod end worn out (came apart) and bearings worn.
1. Jacked up front end of mower.
2. removed nuts/washers from tie rod ends.
3. Replaced new tie rods with old nuts/washers.
4. Removed hub caps from front wheels and cleaned off excess grease.
5. Removed cotter pin, washer, wheel, inner washers, seal, and cap dust cover.
6. Removed inner and outer bearings wi
... Read moreth screw driver and hammer.
7. Replaced bearings and put everything back in reverse order.
8. Added grease to wheels between the bearings and replaced the hub caps.
Pulled the cotter pen
remove the wheel
used screwdriver and hammer to pop out the old bearings
cleaned out old grease
used a hammer and block of wood to hammer in new bearings
re-attached the wheel
grease hub
1. Remove hub cap.
2. Remove cotter pin
3. Slide wheel off.
4. Remove remains of old bearings, washer and clean off old grease and debris.
5. install new bearing using large socket and hammer to drive bearing in place.
6. Put a generous amount of grease inside the wheel assembly.
7. Replace wheel assemb
... Read morely and lock in a new cotter pin.
8. Replace hub cap.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9067729
Manufacturer Part Number: 7011807YP
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
