Belt-v Trans Drv 954-04207

1. Removed mower deck, battery and battery box
2. Lifted front end of mower with mower jack.
3. Used impact wrench to loosen blade clutch bolt.
4. Unplugged clutch and lowered clutch after removing clutch bolt. Collect washers separating clutch from drive pulley.
5. Used screwdriver to slide down drive pulley a ... Read more nd remove belt.
6. Used impact wrench to remove nut holding fan base and transmission drive pulley. (Note: to keep pulley from spinning I cut the old belt and fed one end around the pulley until it started wrapping under itself which bound up the pulley).
7. Route the new belt from front to back, lift transmission pulley and wrap new belt around it pushing it back into place so metal ears keep it from slipping off.
8. Route belt around idler pulleys, work belt onto Drive pulley and push it up into housing like I did on the rear pulley. Pull the spring loaded idler pulley to position the belt that is now under tension.
9. Replace the washers separating the pulley and clutch and slide on clutch with key way in slot. Hold in place while replacing the bolt. Tighten the bolt with impact wrench.
10. Reconnect clutch power cable.
11. Install fan, replace nut and tighten nut with impact wrench.
12. Reinstall battery box, battery and mower deck.
13. Double check to make sure you or I forgot anything.

1. Removed deck from tractor.
2. Snake the belt around the pulleys before removing the old one. Taking a picture will accomplish the same thing. The belts donÆt always go where you think they should go.
3. It was necessary to undo the tension spring, remove the pulley closest to the spring and loosen the bolt on the other te ... Read more nsion pulley.
4. Remove the old belt.
5. Check the spindle connections where they meet the mower deck to verify they are tight. If not, tighten.
6. Put the removed pulley back, tighten the other and reconnect the tension spring.
7. Remove old and Installed new mower blades with impact wrench.
8. Reattach mower deck to tractor.

Removed belts put new ones on replaced deck engagement cable on riding lawnmower 2246 Troy bolt 2011 model use floor jack impact driver take deck off to get to transmission motor belt take your time to make sure everything goes back on right. thanks for the belts and cable all done runs real nice. Need impact driver for pulley on eng ... Read more ine crank shaft to take off.

1) removed mower deck
2) unbolted motor
3) replaced belt
4) replaced all

Drive belt pulley was the hardest . You have drop the engine pulley off the engine shaft and fan on top of the rear hydrostatic drive . Its especially essential to have a hammer drill to do that . Pre soak both both of them with wd40 . On the fan, remove battery and pull out it\'s box holder, seat also . Front and back pulleys need to be ... Read more removed to install drive belt otherwise you can\'t get belt replaced . Did that also at the same time of steering shaft and pinion gear . Remove steering wheel, plus gas tank. Also under side nut .