This is an authentic OEM sourced replacement carbon brush designed for use with Black and Decker lawn mowers. This assembly includes one (1) carbon brush with a lead wire attached. Please note the spring and brush holder are sold separately. Carbon brushes are a commonly replaced item on electric motors. Due to constant with contact with armature brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the brush cap and take out the old brush • Secure the new brush with a cap and test the tool
Troubleshooting
This part works with the following brands:
Black and Decker
This part works with the following products:
Lawn Mower
Part# 241648-01 replaces these:
241648-01, P241648-01,
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Removed Cover (4xT7 screws)
Disconnected +ve battery terminal - covered terminal and tucked cable away.
Removed Brush cover 1x T7... Identified worn brush making less surface contact with Motor armature.
Removed Brush from spring loaded brush holder.
Cut brush connection away from cable.
Crimped new brush con
... Read morenection to cable.
Pushed the brush back into spring loaded brush holder.
Held brush retracted - and slotted brush holder into place. allowed brush to rest against the motor armature
Fitted brush cover.
Repeated for 2nd Brush.
Reconnected +ve battery lead
Re fitted mower cover
Read less
Did you find this story helpful?
Thank you for voting!
Part of the magnet broke in the motor and in turn split the shunted brushes
There\'s nothing difficult with the repair, but using the new terminal to clamp the connect between the power leads and the shunted brush isn\'t too easy to make it neat. But then again it doesn\'t have to be too neat. As long as they are clamped together reasonably, the terminal should fit back in ok to the slot for it in the motor..
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP18980547
Manufacturer Part Number: 241648-01
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
