Husqvarna Trimmer Carburetors

This is a genuine OEM replacement part, it is sold individually. By pressing on the Purge Bulb, it will force fuel into the fuel line from the fuel tank into the carburetor. Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in the fuel return line. Over time the primer will lose its elasticity or crack and need to be replaced. We have an article and video on

This carburetor rebuild kit (part number 545081848) is for lawn and garden equipment engines. Carburetor rebuild kit 545081848 includes gaskets and parts for rebuilding the carburetor. Work in a well-ventilated area and drain the fuel from the tank and fuel lines before rebuilding the carburetor

This is a genuine OEM sourced replacement part used on Husqvarna trimmers and brushcutters. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then ...

This is a genuine manufacturer-sourced replacement gasket repair kit that is specially made for use with Paramount and Poulan lawn and garden equipment. It is utilized to replace carburetor gaskets and diaphragms that were originally installed on a new unit. If you have a problem with your carburetor this will usually take care of it. Keep in mind this high-quality kit is sold individually. Please...

This is an OEM Poulan Carburetor Intake Boot used on gas trimmers to connect carburetor to a carburetor-adapter. This part is made out of Rubber. Over time rubber material can dry out and crack. If this part is warped, cracked or damaged it needs to be replaced for the unit to operate properly.

This is a Genuine OEM rebuild kit designed for Walbro Carburetors. This kit contains all the necessary Gaskets and Diaphragms needed to rebuild your carburetor. If your engine runs sluggish or it dies shortly after starting it, you may need to rebuild your carburetor. Replacing these items you would need a Screwdriver and Pliers.

This is a genuine OEM replacement part, it is sold individually. It is used on specific Gas Trimmers. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts ...

This is an authentic OEM part. The metering diaphragm is a Walbro part that is used inside of carburetors that work with small engines. This part goes between the carburetor body and the fuel pump. This diaphragm is used to help regulate the fuel to maintain the proper air/fuel ratio. This part is priced as a single item.

This is an authentic item that is specially designed for use with Walbro carburetors commonly installed on lawn and garden equipment. Gaskets are generally utilized to provide a tight seal between connected parts, over time the material may wear out and even begin to crack eventually requiring a replacement. This high-quality kit is sold individually, keep in mind it includes all the necessary com...

This is a genuine OEM part. The Husqvarna choke control is made for use with many lawn and garden trimmers. The plastic component is fastened to the carburetor, allowing the operator to manage the engine's fuel and air mixture. A hex key and a wrench may be required for making the repair. The choke control is sold individually.