1. Pull out the water tank.
2. Remove 2 screws on the back of the coffee maker.
3. Remove top cover by gently pooling it back.
4. Remove 2 screws that hold tubing in place (above the coffee dispenser). Be careful not to lose a small capped spring, that inserts inside the tubing (Cap side up).
5. Replace red \"O-rin
... Read moreg\" gasket.
6. Re-assemble. Be careful to properly insert the spring.
Removed the upper cover, removed hose securing clips with pliers, unscrewed mounting screws to cracked part, replaced o-rings and main coffee pressure pod gasket, replaced Cracked Y part, reassembled.
Did you find this story helpful?
Thank you for voting!
Connector broken by the mold seam and the main gasket at coffee filter is crack, on a DeLonghi EC685R.
DeLonghi EC685R with connector and filter gasket broken.
Parts used (from a model EC860):
1 x Gasket [ 537177 ]
1 x Gasket [ 5313221491 ]
1 x Connector [ 5313222031 ]
Instructions:
1. Disconnect power.
2. Remove the water tank.
3. Remove the two Phillips screw (bit #2) from chrome top of the
... Read more machine.
4. Slide a bit back and pull up at the same time, to remove this top.
5. Disengage (pull out) knob of vapor control (knob at right side).
6. Loose the two Phillips that attach electronic of vapor control, and move carefully to one side.
7. Then you will see the connector at the bottom, attach with two Phillips.
8. Remove Phillips and disengage the two tubings connected.
9. To disconnect each tubing, pull the safety pin and pull out the tubing. Take care of the little o-ring that supposes be attach at the tip of each tubing, but frequently keep trap on connector hole.
10. Remove connector with the red o-ring, be careful with the spring with a round plastic tip, that is located below him.
11. Return this spring to the hole, with the plastic tip looking upward. Then place the new connector with a new red o-ring.
12. Go back in steps, from step 9 to step 3. That\'s all!!!
1. Remove 2 screws on the back of the coffee maker
2. Remove 2 screws holding the nozzle (use magnetic screwdriver)
3. Replace a spring, silicone gasket, and gasket holder
4. Reassemble the coffee maker. Make sure the spring stays in place (gasket side up) and the O-ring is in place.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10311733
Manufacturer Part Number: 537177
Espresso Machine
- Espresso (0132126011) Ver:ca, Us
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
✖
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Seal or Gasket","title":"Seal or Gasket","url":"/parts/small-appliance/espresso-machine/seals-and-gaskets/"},{"position":2,"name":"537177","title":"537177","url":""}]
