It is a genuine manufacturer-supplied item that is made for DeLonghi espresso machines. Gaskets are commonly utilized to provide an air-tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Check the diagrams for your model to ensure the correct repair procedure. A screwdriver will be needed to take apart and reassemble the housing.
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Couldn't have been easier
Ordering from eReplacementParts was quick and easy, and the parts arrived in just a couple of days. Couldn't have been better, thanks. (This was an experiment to see if a new gasket would fix a minor leak in my DeLonghi espresso machine: nope, but it was worth a try. The machine still makes a good espresso, it just drips a bit around the portafilter.)
Guest - May 6, 2021
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1. Unscrew the upper filter screen retaining screw and remove screen.
2. Remove the old gasket with a small flat head screwdriver.
3. Install the new gasket.
4. Replace the filter screen and reinstall the retaining screw.
5. Make espresso!
I discovered the machine was leaking water when brewing.
I open the top cover of the machine to see inside and discovered a very small leak that when the machine was brewing with the pressure a very tiny hole was on the Y tube of water distribution.
replacement shows every part on the machine, ordered it and now is Like new!
... Read more if you are handy easy to repair
around 30 mins
Removed the upper cover, removed hose securing clips with pliers, unscrewed mounting screws to cracked part, replaced o-rings and main coffee pressure pod gasket, replaced Cracked Y part, reassembled.
DeLonghi EC685R with connector and filter gasket broken.
Parts used (from a model EC860):
1 x Gasket [ 537177 ]
1 x Gasket [ 5313221491 ]
1 x Connector [ 5313222031 ]
Instructions:
1. Disconnect power.
2. Remove the water tank.
3. Remove the two Phillips screw (bit #2) from chrome top of the
... Read more machine.
4. Slide a bit back and pull up at the same time, to remove this top.
5. Disengage (pull out) knob of vapor control (knob at right side).
6. Loose the two Phillips that attach electronic of vapor control, and move carefully to one side.
7. Then you will see the connector at the bottom, attach with two Phillips.
8. Remove Phillips and disengage the two tubings connected.
9. To disconnect each tubing, pull the safety pin and pull out the tubing. Take care of the little o-ring that supposes be attach at the tip of each tubing, but frequently keep trap on connector hole.
10. Remove connector with the red o-ring, be careful with the spring with a round plastic tip, that is located below him.
11. Return this spring to the hole, with the plastic tip looking upward. Then place the new connector with a new red o-ring.
12. Go back in steps, from step 9 to step 3. That\'s all!!!
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
