This is a genuine OEM sourced replacement part, it is specially designed for use with Homelite generators. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel or it starts and then quickly dies, the carburetor is likely the problem. This is a high-quality metal carburetor assembly which is sold individually.
Troubleshooting
This part works with the following brands:
Homelite
This part works with the following products:
Generator
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
1- 2 hours
(2 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Engine on 2010 Homelite HG5000 was \"surging\" after warm-up and with the choke lever pushed in. I was told by reliable source that carburetor needed replacement.
Pretty straightforward. Had to remove all parts of air cleaner and choke lever assembly, also disconnect fuel hose from old carburetor and two wires which I believe control a solenoid at bottom of carburetor. About a dozen metric nuts (9 and 10 mm) were removed; all bolts remained in place. Carburetor assembly itself just slid off of 2
... Read morebolts. Replaced 1 gasket which stuck to old carburetor on the engine side, slid new carburetor onto bolts and reversed earlier steps. One big caveat: when re-attaching choke lever assembly, be sure the position of the butterfly valve (open or closed) matches the position of the choke lever (in or out, respectively). I didn\'t do this and because valve was open, engine would not start and I had to tear down part way and re-assemble correctly. Then motor started on third pull and ran very smoothly.
1. TURNED OFF fuel supply valve
2. Disconnected fuel line and carb linkages
3. Removed air cleaner
4. Removed carb
5. CAREFULLY removed gaskets from old carb (I should have ordered new gaskets but I forgot)
6. Installed new carb with old gaskets
7. Reconnected fuel line and linkages
8. Turn on fue
... Read morel supply valve and check for leaks
9. Started up.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9873037
Manufacturer Part Number: 099958001707
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
