Part Location Diagram of C310000080 Shindaiwa Chain Catcher
See part B-18 in the diagram
( Grid squares measure 1x1 inch )

Chain Catcher C310000080

Manufactured by:
Shindaiwa
ERP Number:
ERP9315620
Part Number:
C310000080
Original Equipment Manufacturer ?
In Stock
Delivers in 3-5 Business Days!

Easy 

1- 2 hours 

(2 rated repairs) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

The chain catcher attaches to the crankcase. It is a genuine item that is supplied by the original equipment manufacturer for use with Shindaiwa saws. This part is made of hard rubber and is available individually. During the installation process, an allen wrench might be needed to replace this part. It will require replacing if it becomes broken.

Troubleshooting

This part works with the following brands:
  • Shindaiwa
This part works with the following products:
  • Chainsaw

Customer Part Reviews

?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
  • 5 stars
    1
  • 4 stars
    0
  • 3 stars
    0
  • 2 stars
    0
  • 1 star
    0
  • 1
Sort by:  
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

1- 2 hours 

(2 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

chain saw motor mounts worn out

Tom from FLIPPIN, Arkansas

1 person found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Socket set
removed old motor mounts and replaced with new ones
old rubber mounts 10 years old just gave out afters many hours
of abuse, saw is now solid again, ready for many more hours
Did you find this story helpful?
Thank you for voting!

The saw was straight gassed

John from WEST SUNBURY, Pennsylvania

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Wrench set
Pulled the muffler to check for cylinder damage . Pressure/Vac tested to exclude case ,and seal leakage . Removed and replaced P&C , intake boot, base gasket , and some minor parts .
Will run saw on 36-1 mix for a few tanks .
Did you find this story helpful?
Thank you for voting!
  • 1