Genuine Echo Replacement part, this item is sold individually. The A226000032 Air Filter is used to keep dust and debris from contaminating the carburetor and engine. This filter is used on all the Echo Blowers listed below. When this Filter gets clogged and dirty it will diminish the performance of the engine. It should be replaced at this time.
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Good part worked as expected
Arrived before expeced, exact fit
Guest - May 29, 2019
Verified Purchase
★★★★★
★★★★★
Perfect
Perfect fit replacement.
Ronn - November 7, 2019
Verified Purchase
★★★★★
★★★★★
Perfect fit
Packaged safe and all fit great!
Guest - March 30, 2020
Verified Purchase
★★★★★
★★★★★
worked great at a fair cost....great work folks.....
look above......thanks
Guest - April 23, 2020
Verified Purchase
★★★★★
★★★★★
Excellent replacement
perfect fit
Guest - May 12, 2020
Verified Purchase
★★★★★
★★★★★
Leaf Blower Repair
The air filter and carburetor for my backpack leaf blower arrived very quickly. Replacing both parts took no time at all and the blower is functioning like a new blower again.
Guest - December 2, 2020
Verified Purchase
★★★★★
★★★★★
Awesome!
Fit perfectly and now it runs freat
David - January 15, 2021
Verified Purchase
★★★★★
★★★★★
Thanks
Arrived quickly and was correct part. Glad eReplacementParts is there...
MICHAEL - April 13, 2023
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Carburetor Repair Kit and Air Filter
1. Removed air filter cover and filter
2. Disconnected Fuel Lines and throttle cable to Carb
3. Cleaned Carb and port hole with Amsoil carb cleaner
4. Pulled carb apart and put new gaskets, seals, needle and screen in
*Pay attention to the layout of the gaskets and diaphra
... Read moregms when pulling apart
5. Put carb back together
6. Reattached fuel lines and throttle cable
7. Put new air filter in and replaced cover
* Blower runs better than it did when it was new. Took it in for warranty issues and nothing changed when I got it back. Ran it for several years on choke but the diaphragm finally gave out.
Backpack Harness Assembly
1. Bend the hooks to remove old harness from bottom of blower
2. Push harness through the top of harness and remove plastic clips and pull harness off
3. Put bolt through holes on the new harness with washers on either side and tighten nut
4. Push harness through slots on top of blower and attach plastic clips
5. Attach metal hooks to bottom of blower and bend so they don\'t come unattached
Remove two screws to the carburetor unhook the throttle cable and replaced the carburetor.
I had to make a couple adjustments on the carburetor to the gas and air.
Runs perfect now.
Removed the engine, and gas tank, took of the padding and straps. Removed the bolts that holds the 2 frame pieces together, because new bolts must have been another part, that I didn\'t order. Installed the old bolts, re-installed the gas tank and motor, then padding and straps.
Took off the air cleaner case, and replace it and the
... Read morefilter with the new parts.
Note the bolts from the motor through the top of the frame are held only by the plastic frame towards the operator when worn, when tightening them they pulled through the frame. I added washers around those bolts and its holding great.
1. Removed carburetor, disassembled it, and cleaned with spray carb cleaner.
2. Installed new gaskets, diaphragm, etc., and re-assembled carburetor. (I bought new purge base because the rubber check valves inside can sometimes go bad.)
3. Replaced fuel lines and fuel filter. (Lines are long and are two different diameters.)(L
... Read moreines enter tank through special rubber plug.)
4. Cleaned spark plug.
5. Installed new paper air filter.
6. Poured in pre-mixed fuel and pumped primer 10+ times.
7. Took several cranks, but it runs well now. Didn\'t even have to adjust the High & Low mix screws.
Removed the air cleaner cover,then removed the old air cleaner. Installed the new air filter and put the air cleaner cover back on. Then just installed the new tube.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_10.gif "Part Location Diagram of A226000032 Echo Air Filter")
_WW_10.gif "Part Location Diagram of A226000032 Echo Air Filter")
