Part Location Diagram of 591160 Briggs and Stratton Carburetor
See part E-125A in the diagram
( Grid squares measure 1x1 inch )

Carburetor 591160

Manufactured by:
Briggs and Stratton
ERP Number:
ERP9290257
Part Number:
591160
Original Equipment Manufacturer ?
$57.95
Special Order

Easy 

15 - 30 mins 

(1 rated repair) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

This is an OEM part sourced directly from the manufacturer. The carburetor is commonly found in engines from Briggs & Stratton. This is a complete carburetor assembly that comes with two flexible rubber gaskets, and it is used to mix fuel and air together for ignition in the engine. You may require a wrench when replacing these parts.

Troubleshooting

This part works with the following brands:
  • Briggs and Stratton
This part works with the following products:
  • Engine

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Engine would start, then immediately stall. Suspected carburetor, but could find no problem with it, so ordered a new one. Runs better than new, so suspect some defect with original carburetor.

Raymond from Celina, Texas

2 of 2 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Socket set
Parts Used:
591160
1. Remove recoil starter from top of engine.
2. Remove air filter cover and air filter.
3. Pinch fuel hose with vise grips and remove hose from carburetor using pliers.
4. Remove old carburetor - 4 bolts (2 socket sizes), air hose and automatic choke linkage.
5. Install new carburetor in reverse order of above.
Did you find this story helpful?
Thank you for voting!
  • 1