Coil A411000910

FRIST all ordered the parts I need to fix the problem. Like the carborater , coil, spark plug, gaskets needed to repair my weed eater. Not to mention got all the parts i need from E Relacement Parts.com. Machine starts easy and runs a lot better .

1-Removed muffler cover.
2-Removed cylinder cover
3-Removed spark plug cap and coil wire terminal.
4-Removed old coil.
5-Feed coil wire through rubber grommet in engine housing.
6-Install new coil.
7-Set the magnet and coil gap with a business card, if you don\'t have a gauge, card measures close to ... Read more 14 thousandths.
8-Rest of the job is in reverse

1 removed boot from spark plug
2 removed torx screws from cover
3 removed spark plug
4 removed spark plug boot and wire clip
5 removed cover to access coil
6 removed old coil
7 installed new coil using business card to gap between new coil and magneto
8 place boot over new plug wire that came on ... Read more new coil.pulling wire completely through boot
9 attach wire clip to plug wire end firmly
10 fished wire and clip back through boot (steps 9 and 10 are the most time consuming )
11 replace cover
12 replace plug and install boot on plug
13 pulled recoil rope and it started right up

1. Checked for fire to the spark plug and found none;
2. Used multi-meter to check continuity of old coil to determine it was bad;
3. Removed casings from trimmer;
4. Removed spark plug cap and spring from old coil wire;
5. Pulled spark plug wire through rubber grommet;
6. Removed old coil;
7. Installed ... Read more new coil;
8. Pushed spark plug wire through rubber grommet (a little light oil or silicone makes this easier);
9. Installed spring onto plug wire and slid cap onto plug wire;
10. Installed casings onto trimmer;