Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Got the right part, fit perfect, back up and running.
The exact piece I needed, brand new, works perfect. it took a bit of time it being from a mower no longer made. But they keep me updated, great communication, and found it! great job! Thank You E Replacement Parts.com.
Guest - June 20, 2019
Verified Purchase
★★★★★
★★★★★
Good part and right part also.
Same as above
Guest - July 5, 2019
Verified Purchase
★★★★★
★★★★★
worked
worked great
Guest - October 5, 2019
Verified Purchase
★★★★★
★★★★★
replacement part. Part fit perfect
Part arrived in the time frame that was reasonable.
Guest - November 6, 2019
Verified Purchase
★★★★★
★★★★★
Easy repair
came on time.
Brandon - May 23, 2020
Verified Purchase
★★★★★
★★★★★
worked as expected
great service thanks for your help
Guest - May 26, 2020
Verified Purchase
★★★★★
★★★★★
geat service and easy to use web site.
it was the part i needed. Thanks
Guest - June 30, 2020
Verified Purchase
★★★★★
★★★★★
simple repair
Arrived quickly, perfect match to the old one. My mower purred like a kitten after putting it on.
James - July 6, 2020
Verified Purchase
★★★★★
★★★★★
Easy to work with.
The part was a perfect fit and came When promised. Thank you.
Guest - August 7, 2020
Verified Purchase
★★★★★
★★★★★
Right part, good price
The part arrived quick, perfect fit
Guest - June 28, 2022
Verified Purchase
< Prev
1
2
Next >
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
Easy
15 - 30 mins
(29 rated repairs)?
< Prev
1
2
3
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Starter wouldn\'t work without shorting across solenoid
After checking the battery and connections, I felt the solenoid was probably the problem. Luckily, that turned out to be the case. So, for $20, I saved a trip to the repair shop and probably about a $150 repair bill.
Took phillips head to remove cover plate disconnect battery. Inside I took the wires on the terminals of the old solenoid and unbolted the solenoid then replaced with new.
This was very easy and no one should have any problem replacing.
Did you find this story helpful?
Thank you for voting!
My lawn tractor would not crank so I isolated the problem to be in the electrical system. I jumped the two connections on the solenoid and the starter jumped so I knew it needed to be replaced.
I disconnected the battery, opened the access panel and disconnected the old solenoid and replaced it with the new one. Reconnected all the wires and along with the battery and it cranked over just like it was suppose to. Easy fix but the access to the part I was replacing was a little tight. It took about 20-30 minutes to replace sole
... Read morenoid.
Read less
Did you find this story helpful?
Thank you for voting!
Would not turn over,no voltage at starter with key in start position using volt/ohm meter.battery fully charged.
Disconnected battery removed access panel (two screws) on my Murray 48 inch mower. Access panel is just fwd of operators seat vertically centered with steering wheel. If your memory chip isn\'t real sharp anymore,you may want to take a photo of the wire connections, remove wires from solenoid just inside access area (five wires). Remove (
... Read moretwo) bolts mounting solenoid in place,remove old solenoid. I cleaned the mounting surface on mower with sand paper. Clean and inspect wire and wire ends (crimps),you probably call them connectors or splices, any bad ones cut them off and crimp on a new one (wire crimping tool kit required). Then, reverse mode mount new solenoid connect wires (from your photo) just kidding. Connect battery,op\'s check went good. Spray some battery terminal protector on your wire connections and at base of solenoid, install access panel
Tested the solenoid with a meter. It was bad. Removed the battery cables. And the cables from the solenoid. Removed the old solenoid and replaced it with the new one. Attached all of the cables. The tractor cranked right up. Thank you.
Remove the cables from the battery, then from the solenoid. Remove the old solenoid and install the new one. Connect all of the cables. We\'re running now.
Checked starter - ok / had hard time getting to solenoid to test but given inexpensive price ordered part before confirming faulty solenoid. Part was as advertised and compatible. A true pleasure dealing with e-replacement parts.
I removed the cables from the battery, then from the solenoid, Removed the solenoid and installed the new one, replaced the all of the cables. It starts every time now.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_2.gif "Part Location Diagram of 7701100MA Murray Lawn Mower Solenoid")
_WW_2.gif "Part Location Diagram of 7701100MA Murray Lawn Mower Solenoid")
