This is a genuine manufacturer-sourced replacement part which is specially designed for handheld lawn and garden equipment. The switch allows a user to turn the unit on and off, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. Unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body switch is sold individually.
Removed old switch. replaced with new one. Bought clutch tool along with new clutch. Removed side cover, bar, and chain. removed spark plug and inserted small piece of rope so that it would not try to start. Took clutch tool and removed clutch. Installed new clutch and put back together.
Both repairs were done without any disassembly. On/off rocker switch can easily be reverse repaired. Note wiring before removing old switch assembly. Remove the old spark pluge , then installed the new one.
Did you find this story helpful?
Thank you for voting!
Saw on off switch inoperative and only way to turn off was disconnected spark plug.
Pry old switch from body of saw.
Use players to separate connections
Attached new connections
Press switch into saw body
Confirm replacement by using switch to start and stop saw
Unscrewed four screws that hold the housing together, pushed switch out of housing, disconnect two wires from switch. Connect wires on new switch, push new switch into housing, screw housing back together. Good to go. No special instructions, remember housing is plastic don\'t cross thread the screws
Did you find this story helpful?
Thank you for voting!
The on/off switch was faulty and didn\'t function properly.
The switch replacement was relatively simple and straight forward. I separated the handle exposing the switch. Using a pair of needle nose pliers I removed the two (2) wires connected to the switch. Gently prying the old switch from the case was easy and only required the use of a thin flat blade. The new switch was placed into the ope
... Read morening and popped into place. Reattching the two (2) wired is sort of tedious within the tight space. Again, the needle now=se pliers worked well.
Reattaching the handle pieces requires some trial and error moves. Getting the throttle lever back in place is very critical at this point..The throttle lever is only held in place by pressure from the handle halves. Before attaching the screws be sure to actuate the throttle lever to assure it moves freely both in and returns on its on to the neutral position.
Attaching the screws is a simple step with you T25 Torx bit.
Check for proper operation by following your prescribed starting procedures.
Happy trimming
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9004922
Manufacturer Part Number: 530069572
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
