Troybuilt TB146 EC tiller - four stroke
1.) Removed the 4 - 5 top cover screws
2.) Removed the air breather cover, filter and filter grate, and assembly. See the spacers in the housing for the long bolts put them back, a big help to have.
3.) Removed the carburetor.
4.) Disconnected the throttle connection from
... Read morethe carburetor.
5.) Lift and discounted the throttle cable securement from the body of the motor, use two standard screwdrivers to push in on both sides of the holder, it just lifts off and out of the way.
6.) Remove the carburetor gasket, big cardboard piece. Remember to tuck in under the plastic housing when reinstalling
7.) Remove and reinstall the spark plug if needed, did they come pre-set, the carb too.
8.) Re-install in reverse.
9.) Change the oil while you are there. Do not overfill or it will run out of the air breather assembly.
10.) The power bit starter is great, all small engines should have one of these. A standard square bit, I bet would work too.
The repair was easy due to the parts matched exactly
Removed air cleaner
Removed screws that held the Carbuerator on
Removed fuel lines
Removed throttle cable assembly
Removed old gasket/ heat barrier
Replaced all parts cut fuel line used the supplied connectors
Put the trimmer back toget
... Read moreher
Primed the carb and it started within 3 pulls runs just like new
Read less
Did you find this story helpful?
Thank you for voting!
The carburetor was over 10 years old and wouldn\'t prime gas anymore.
Remove the air cleaner cover and filter. Remove the fuel lines and throttle from the carburetor. Remove the screws that connect the air filter base and carburetor to the cylinder.
Remove the old o-ring, carburetor and gasket. Install the new gasket, carburetor, o-ring and the air filter base and tighten the screws. Install the throt
... Read moretle and fuels lines. Install the filter and the air cleaner cover.
Replaced carb and gasket
Replaced all fuel lines
Replaced fuel filter
NOTE: the fuel filter is INSIDE the fuel tank on the end of the fuel line. Feeding a new fuel line into the tank and attaching the fuel filter is extremely difficult. This took up most of my time.
WARNING: do not omit the fuel filter or one lit
... Read moretle gob of crud from the tank will negate all your repair work and ruin your new carb.
Recommendation: include a longer fuel line and an IN-LINE fuel filter with the carb kit
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP19282893
Manufacturer Part Number: 753-05366
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_(2007)_WW_1.gif "Part Location Diagram of 753-05366 Husky CARBURETOR GASKET")
_(2007)_WW_1.gif "Part Location Diagram of 753-05366 Husky CARBURETOR GASKET")
