Removed the end bell
Removed the bearing
Took off the old (2 wires, 2 mounting screws)
Installed the new (2 wires, 2 mounting screws)
Partially installed the bearing
Installed the end bell and bearing
First make a mark on the motor and the motor cover so you can line up the screw holes when you put the motor cover back on. Remove the four screws then use a mallet to hit the motor cover off. Pull the bearing out of housing, then install the new bearing. Next make a mark on the shaft where the start switch is located. Note how the start
... Read moreswitch is assembled. Remove the old switch and install the new one. Use a rubber hammer to put motor cover back on, put the four screws back in.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP19152516
Manufacturer Part Number: JT9-JBG10A-66
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of JT9-JBG10A-66 Jet CENTRIFUGAL START SWITCH")
_WW_1.gif "Part Location Diagram of JT9-JBG10A-66 Jet CENTRIFUGAL START SWITCH")
