Remove all of the part opposite the feed shaft. Replace in the correct position with the quill. I replace the handles also. Remove screw securing set ring, remove it and replace it with the new one.
1. Rolled deck up to 2ö below drill chuck
2. Places a short 2 x 4 block between deck and chuck
3. Removed double nuts from shaft
4. Carefully remove the spring cup and spring
5. Carefully taped the broken shaft out until it could be removed by hand
6. Installed new shaft
7. Reinstalled spring with cap
... Read moreand first nut to shaft
8. Using needle noise pliers to control and tension spring in counterclockwise direction to create recoil when releasing drill handle
9. Tighten nut to keep spring cap on tab
10. Reinstall locking nut and tighten the two nuts
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of JT9-17373839 Jet FEED SHAFT ASSY")
_WW_1.gif "Part Location Diagram of JT9-17373839 Jet FEED SHAFT ASSY")
