Part Location Diagram of 5140074-50 DeWALT BRUSH HOLDER
See part 10 in the diagram
( Grid squares measure 1x1 inch )

BRUSH HOLDER 5140074-50

Manufactured by:
DeWALT
ERP Number:
ERP18981705
Part Number:
5140074-50
Original Equipment Manufacturer ?
On Order

Easy 

Less than 15 mins 

(3 rated repairs) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

This is an original Porter Cable replacement part. The brush holder is found in a Porter Cable bandsaw. This part is made of metal, and is used to hold the brush that constantly cleans sawdust and debris from the lower wheel. You will require a screwdriver when replacing this part. This item is sold individually.

Troubleshooting

This part works with the following brands:
  • Porter Cable
This part works with the following products:
  • Band Saw
Part# 5140074-50 replaces these:
5140074-50,

Customer Part Reviews

?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(2 Reviews)
Click to filter by ratings:
  • 5 stars
    2
  • 4 stars
    0
  • 3 stars
    0
  • 2 stars
    0
  • 1 star
    0
  • 1
Sort by:  
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

Less than 15 mins 

(3 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Replace safety power switch, brush and holder worn

Tim from Omaha, Nebraska

1 person found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
With a small screwdriver, press on the small plastic tabs on the bottom and top of the switch, and remove it from the housing, just far enough to exchange the wires.
To get the correct wires on to the new switch, remove the wires one at a time from the old switch and connect them to the new switch.
Press the new switch back in to the housing.
Unscrew the old brush and holder from the base.
Screw on the new brush holder
Press the new brush on the holder
Did you find this story helpful?
Thank you for voting!

Closing clip was broken and little brush. Replaced with new parts

William from Shallotte, North Carolina

1 person found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Replaced broken clip in upper wheel cover. Then I replaced the brush holder and the worn brush
Did you find this story helpful?
Thank you for voting!

Worn and broken parts

william from healdsburg, California

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Replaced defective parts
Did you find this story helpful?
Thank you for voting!
  • 1