Unplug saw turn saw upside down on suitable support ,remove blade, snap ring retainer at end of shaft and friction washer. Inside the housing back off the crank handle until shaft is out of the cross bar. If the shaft is stripped and will not come out of cross bar, hacksaw the shaft off near the handle. There is a double nut lock 14 mm in
... Read moreside of saw base housing . Also there is friction washer, remove crank handle, remove center trim cover. Replace shaft reverse process. When install double nut depth is set for the amount of drag on the housing. Align the cross bar when setting depth, to much clearance will allow the snap ring come off end of the shaft. Be sure to order enough parts to make the job complete. Nuts washers and clips. Joe M.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
