For Blade: Lift Lawn Tractor onto rear stands to reveal blade and remove with 3/4 in. Socket and Wrench (2 Bolts). Since this is an \"air lift\" blade the lift \"wings will have to be transferred to new blade (3 bolts each on two wings). Add anti-seize to bolts before reattaching.
For Belt: Set cutting deck to lowest leve
... Read morel for easy removal of belt shield. Remove belt shield and loosen guides to remove and replace belt. Shifting to a high gear can help with getting belt past engine pulley. Reattach guides and adjust belt, then re-install shield.
It definitely was pretty easy putting this belt on.
I sent an email to eReplacement it brought me to a website and there it was itÆs definitely made my day ordering from you thank you
Did you find this story helpful?
Thank you for voting!
Friction drive ring had to be replaced and also the mower deck drive belt replaced
The only hard part is getting the belt past the drive system to the drive pulley off the engine without lifting the engine, I could not find any instructions for replacing belt but loosening engine mounting bolts gave enough clearance to get the belt past the drive, this is a old Snapper riding lawn mower,
Did you find this story helpful?
Thank you for voting!
The pulley bearing burned out and caused excessive wear on the belt. New pulley and belt and the rider cuts as well as it did new
Took the cover off, removed bolt from pulley, replaced pulley with new bearing included, removed belt (hint: have it in neutral and do not force it; it fits! depressing the clutch while sliding it past the drive wheel helps a lot). If you cannot do it with these simple instructions you should take it to a lawn mower/tractor shop before st
... Read morearting this project
Read less
Did you find this story helpful?
Thank you for voting!
Old parts
Kelly from FREDERICKSBURG, Virginia
1 personfound this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers, Wrench (Adjustable), Wrench set
Lawn Tractor
- 26" 8 Hp Rear Engine Rider Series 4
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
