Part Location Diagram of 5650873018 Skil Spring Washer
See part 21 in the diagram
( Grid squares measure 1x1 inch )

Spring Washer 5650873018

Manufactured by:
Skil
ERP Number:
ERP17573446
Part Number:
5650873018
Original Equipment Manufacturer ?
$6.16
Special Order

A Bit Difficult 

15 - 30 mins 

(1 rated repair) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

This is a special item that provides a tight fit between connected parts. Over time it may wear out, get damaged or lost eventually requiring a replacement. Check the appropriate diagrams for your model to ensure the proper repair procedure. This high-quality spring washer is made of durable material and is sold as an individual item. It is a genuine manufacturer-supplied product that is made for Skil and Bosch circular saws.

Troubleshooting

This part works with the following brands:
  • Skil
This part works with the following products:
  • Saw

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

15 - 30 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Broken off bolt on saw angle adjustment

John from Lombard , Illinois

1 person found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Determined missing parts from parts listing. Ordered parts.Loosened front blade shield (4 screws) Used punch to drive out roll pin on pivot allowing clearance to remove broken head of carriage bolt. Inserted new bolt, put blade guard in position and put screws back. Aligned clevis to permit re-insertion of the roll pin. Job complete. A $7 .00 saw from second hand shop back as good as new for $12.
Did you find this story helpful?
Thank you for voting!
  • 1