( Grid squares measure 1x1 inch )

Repair Kit 261-TK2

Manufactured by:
Ingersoll Rand
ERP Number:
ERP12095529
Part Number:
261-TK2
Original Equipment Manufacturer ?
In Stock
Delivers in 3-5 Business Days!

A Bit Difficult 

1- 2 hours 

(1 rated repair) ?

Does this part fit my model?

Need help finding your model number?

Troubleshooting

This part works with the following brands:
  • Ingersoll Rand
This part works with the following products:
  • Wrench

Customer Part Reviews

?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
  • 5 stars
    1
  • 4 stars
    0
  • 3 stars
    0
  • 2 stars
    0
  • 1 star
    0
  • 1
Sort by:  
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

1- 2 hours 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Trigger seal was bad. Impact wrench would continue to run when air was applied without trigger being pulled

Jason from Summerfield, North Carolina

2 of 2 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
Parts Used:
261-TK2
Remove 4 Allen screws to nose cone (anvil)
DonGÇÖt remove the anvil out of cone
Remove washers and top bearing
Pull rotor with veins
Pull rotor housing to get to lower bearing
Assembly in reverse order
Kit comes with new rotor veins
Replace top bearing
And gasket
Install anvil housing and tighten Allen bolts
Remove air fitting assembly
Pull the trigger needle out under spring
Use pick to remove seal
Reassemble in reverse order
Did you find this story helpful?
Thank you for voting!
  • 1

Model Cross Reference

This part works with the following models:
ERP Number: ERP12095529
Manufacturer Part Number: 261-TK2
Brand Model Number Description
Ingersoll Rand 261 Wrench - Air Impact Wrench
Ingersoll Rand 261-3 Wrench - Air Impact Wrench
Ingersoll Rand 261-6 Wrench - Air Impact Wrench
Ingersoll Rand 271 Wrench - Air Impact Wrench