This is an authentic Honda replacement part that is sourced from the original manufacturer for use with lawn mowers. The push nut is made out of metal. It might require a screwdriver, a set of pliers, and a wrench set to replace this part if it becomes broken. This item is sold individually.
Remove the push nut from the shaft holding the shield
Remove the shaft from the mower and the old shield
Push the new shaft through the hole in the mower and the the shield and through the mower on the other side.
Install the new push nut
1. Replaced front/rear wheels and rebuilt/lubed drive sprag\'s at ends of transmission shafts.
2. Replaced all metal shields on lower portion of mower.
3. Replaced drive (V) belt.
4. Removed, sharpened and re-install cutting blade set.
5. Adjusted smart-drive cable (will probably replace at a later time).
6.
... Read moreWill replace pull-starter assembly once it is received (on a different order).
Reattached push nut on rear rod that holds the rear shield
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
(VIN_MZCG-6000001_to_MZCG-6299999)_WW_5.gif "Part Location Diagram of 90301-VG3-020 Honda Nut, Push (3.96mm) (flat Round")
(VIN_MZCG-6000001_to_MZCG-6299999)_WW_5.gif "Part Location Diagram of 90301-VG3-020 Honda Nut, Push (3.96mm) (flat Round")
