This genuine Milwaukee replacement switch and handle service kit is specially designed for impact wrenches. It is sourced directly from original equipment manufacturer. This set contains both the left and the right sides of the handle and the mechanical switch that controls the on/off functions of the tool. These parts are made from durable plastic and it is sold individually. Replacing this set you will need a torx screwdriver.
Troubleshooting
This part works with the following brands:
Milwaukee
This part works with the following products:
Impact Driver
Videos For installing this part.
?
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1 Remove screws from all around the plastic handle and the four from the impact end
2 Parted the two half\'s of the plastic housing
3 Because I was using the Switch and Handle Service Kit, put the new switch, pcb card and brush set in the new handle make sure you rout the cables in right places as to not trap any of the wires
... Read more and insert the screw provided in to the pcb card then lift out the brush ring and insert the armature into the ring having first puled back the brushes buy releasing the springs, then make sue all the brushes are are back under pressure from the springs and none of the wires are trapped or wrapped around the springs.also position the four little plastic slugs two in one half of the new handle and two in the other look in the old handle to see where they fit but they are for a cushion between the plastic handle and the gearbox.
4 Carefully position the the brush ring compete with the motor and gearbox into the one half of the handle pay particular attention to the little square nibs that locate the Brush-ring the motor outer body and the gearbox there are three of them and can be tricky to locate make sure the two holes for two of the gearbox mounting screws lineup to know if the motor assembly is fully in the right place and the bearing by the brush-ring is fully in is location or the other half of the handle will not go on
5 Position the other half of the handle and refit all the screws around the handle and gearbox
Removed screws holding the housing together
Removed switch assembly
Installed rubber bumpers into new housing
Installed new switch assembly
Installed other half of new housing
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP11877307
Manufacturer Part Number: 23-66-0102
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW.gif "Part Location Diagram of 23-66-0102 Milwaukee Switch And Handle Service Kit")
_WW.gif "Part Location Diagram of 23-66-0102 Milwaukee Switch And Handle Service Kit")
