This is a high-quality ring is made for use with impact drivers. It is an authentic item which is supplied by the original equipment manufacturer. This rubber ring provides a tight seal for the anvil assembly. Over time it may wear out and begin to crack eventually requiring a replacement. For the exact location and the correct installation check the diagrams of your model. This high-quality rubber ring is made of a durable material and is sold as an individual component. You will need a screwdriver to take the tool apart when performing this repair.
Troubleshooting
This part works with the following brands:
Milwaukee
This part works with the following products:
Impact Driver
★
Customer Part Reviews
?
1.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
5 stars
0
4 stars
0
3 stars
0
2 stars
0
1 star
1
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
moderately happy
The part is difficult to install without distorting it. Due to the distortion, the socket jammed onto the tool having to use pliers to remove it further damaging the new part. Had to remove the new part and dispose of it.
Guest - July 22, 2019
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1) Hold impact firmly facing upward.
2) Insert pick lengthwise from side, forcing ring outward.
3) Insert small flathead screwdriver from top, and pry retaining ring out and off.
4) Replace rubber o-ring underneath, and grease.
5) Use 1/4\" deep socket barely larger than anvil head, place snap ring on top of anvi
... Read morel, and with a small hammer, pop retaining ring over the round edge and into place on anvil.
6) Grease retaining ring and squeeze closed with pliers, then slide impact socket on several times to seat.
Addendum: Description is wrong. It is a \"Retaining Ring\" not a rubber ring. It is hardened steel with a rubber flat ring underneath, sold as a kit.
1. Disassembled the impact gun.
2. Unpacked new parts and laid them out on workbench
3. Disassembled gear train, cleaned, regreased and reassembled.
4. Soldered motor leads from controls to motor ( they are marked )
5.Using old parts as a guide assembled new parts to gearcase then into new handle.
6 Installe
... Read mored screws and special clip in battery well.
7. Finally removed old hog ring and rubber ring and replaced with new ones.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP11877050
Manufacturer Part Number: 14-46-1005
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 14-46-1005 Milwaukee Rubber Ring")
_WW_1.gif "Part Location Diagram of 14-46-1005 Milwaukee Rubber Ring")
