Gear-pinion, 13t 131-0896

1. Remove plugg wire so engine can\'t start
2. Remove remains of drive belt. You have to remove a bracket umder the engine and on top of the transmission to do this. This involves removing 2 of the engine mount bolts. The bracket on the transmission uses Roberts bolts requiring a special driver. This will disconnect the control ... Read more cable also.
3. Remove the drive wheels.
4. Remove the pinion gears. This requires a snap ring pliers.
5. Remove the axle bearing assemblie from the frame. The transmission will now fall out.
6. If new bearings are going to be installed, use a hammer and pu ch to drive the old bearings out.
7. Use a vise, press or hammer to press in the new bearings.
8. Hold the transmission in place and install the axle bearing assemblies.
9. Install the pinion gears.
10. Install the drive wheels.
11. Install the drive belt.
12. Install the bracket on the transmission.
13. Install the bracket under the engine to retain the belt.
14. Reconnect the plug wire.

Removed wheels, pinion gears and bearings
Reverse order to reassemble