This item is an authentic OEM sourced part that is intended to be used with DeLonghi coffee makers. It is an identical replacement for a damaged or a missing component that was installed on a new unit. It is made of high-quality material and is sold as an individual item. Refer to the appropriate diagrams for your model to ensure the correct repair procedure. A screwdriver will be needed to take apart and reassemble the housing.
Troubleshooting
This part works with the following brands:
DeLonghi
This part works with the following products:
Coffee Maker
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
15 - 30 mins
(3 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
The brew unit would not go into the home position. Brew unit would go all the way up and stay after machine was turned on. Unable to brew shots or steam.
The hall sensor is located on the bottom of the transmission assembly. You have to remove the transmission to replace it as far as I could tell. Remove the brew unit, remove the hex screw located behind. This is the screw that holds the transmission assembly in place. To remove the brew unit on from the back I did find it necessary to rem
... Read moreove the screws mounting the water boiler so it could move out of the way. Once removed, observe the hall sensor board on bottom. Replace and route wires to the control board.
The connection mentioned in the parts was the connector on the output side of the water solenoid valve. Mine leaked causing the damage to the hall sensor.
Read less
Did you find this story helpful?
Thank you for voting!
Delonghi Magnifica Espresso Machine boiler and solenoid not working
eReplacementparts has a very good video on You-Tube showing exactly what was needed in order to facilitate the repair. I followed the video while doing repair and there were no issues.
1. removed sides
2. removed screws holding part in place
3. removed clips holding water lines in place.
4. replaced part.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
✖
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Wire Plug or Connector","title":"Wire Plug or Connector","url":"/parts/small-appliance/coffee-maker/wire-plugs-and-connectors/"},{"position":2,"name":"5332188800","title":"5332188800","url":""}]
