This is a genuine OEM approved replacement part designed for use with Bissell vacuum cleaners. It spins to pick up the dust and dirt from the carpet. This part is made out of plastic and it is sold individually. When replacing this part you will need a screwdriver. • Remove access plate and take off the belt • Remove old brush roller and snap the new one into place • Connect belt to the spindle • Secure the access plate
Troubleshooting
This part works with the following brands:
Bissell
This part works with the following products:
Upright Vacuum
Carpet Cleaner
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(2 Reviews)
Click to filter by ratings:
5 stars
2
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Saved us a new vacuum cleaner
The part was easy to install. My wife actually did the work and is thankful to have our vacuum cleaner working again. Took some time to get this "discontinued" part.
Guest - July 4, 2019
Verified Purchase
★★★★★
★★★★★
Vacuum cleaner brush
Item arrived quickly and was as described.
Guest - January 20, 2020
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Belt and brush housing cover on this Bissell model 4104-C upright vacuum needs no tools to remove they use push tabs. Remove cover. Slide out old brush assembly, remove belt -mine was broken-, slide belt over belt groove roller end and then slide opposite end into brush slot, push belt onto motor spindle and pull the belt end of brush ass
... Read moreembly to line up with 2nd slot and slide into place. Replace cover.
Read less
Did you find this story helpful?
Thank you for voting!
The bearings in the brush assembly (or beater bar) wore out.
1. Used a screw driver to pry back the clips holding the brush assembly cover in place.
2. Removed the old brush assembly.
3. Installed the new brush assembly by inserting it into the two slots at the ends.
4. Replaced the brush assembly cover.
Did you find this story helpful?
Thank you for voting!
The belt broke and the roller was not turning easily.
Ordered proper parts with model number and replaced parts damaged. Very easy to replace parts took only a few minutes. Much easier than replacing entire vaccuum. Thank you e-replacement parts for your prompt delivery of parts which only took a few days to get. Happy Holidays!!!!
Remove the access plate
Remove the old brush roll and the old belt
Install the new belt around the motor shaft
Install the belt around the brush roll
Insert the brush roll into the housing
Install the access plate
When installing and removing case Drum Assembly leave the handle down
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
