This is an original replacement part sourced directly from the manufacturer. The arbor nut is found in DeWALT table saws. This part is made of metal, and is used to secure the blade and arbor assembly. Please be aware that there are different nuts used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The arbor nut is sold as an individual replacement part.
Troubleshooting
This part works with the following brands:
DeWALT
Black and Decker
This part works with the following products:
Table Saw
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1. Tapped out old arbor with brass hammer after removing pulley.
2. Put new arbor in freezer for a couple of hours to shrink it.
3. Lubricated arbor bearings outer race with white grease so wouldn\'t rust.
4. Dropped in new arbor without any force what so ever.
5. Put pulley back on and tightened nut to pull i
... Read moren and hold bearings.
6. Aligned heel on blade and fence.
7. Worked fine, all was good.
Replaced it with a lot less problem than I anticipated.
By tilting and adjusting the position of the arbor I was able to remove the retaining nut. I used a hammer to drive the old arbor out of the bearing. I replaced the left bearing as well as the arbor using a wood block to tap both into place. I used the retaining nut to pull the arbor into place. This wad somewhat difficult because I had t
... Read moreo put the pulley on the shaft as well. Getting all of that aligned was not easy especially working under the saw table. Suggest cutting a block of wood to slip on the threads in place of the pulley then using the nut to pull the arbor into the left bearing. Then add the pulley.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10171036
Manufacturer Part Number: 388956-00
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
