Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
BEWARE! My Dewalt plunge router DW-621 would only run for a secnd
When I checked it out I read that others had this issue and it was the rheostat that was not functioning properly. This is no simple rheostat it will maintain the set speed under a load, a feature essential in the work I do. The replacement cost is $130.oo so I checked to see what a new router would cost and it was about double that. For a few seconds I pondered getting a new router, that way it was ALL new. I opted for a new electronic rheostat. installation was a snap although the plastic guide the lead wires were threaded through placed both wires directly on the metal devices for the bare rotor electrical contacts, big fat alarm! I removed a small thin portion of the plastic guide, running the wires up and over the guide and well away from the electrical contacts. This was the same way the original rheostat was wired, now I knew why. BEWARE: Make sure you re-route the wires to the safe route on this router rheostat! (I just couldn't resist, pun intended:) LOL The install was easy taking 5 minutes max, runs like a champ now.
Guest - June 17, 2023
Verified Purchase
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
Easy
15 - 30 mins
(4 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
I was able to disassemble the switch mechanism, removed 2 wires, and 2 more screws from the top and the variable speed control lifted away. The new control was replaced reversing the above procedure.
Router now works like a new one.
I removed the plastic housing on top, side, and switch handle, disconnected 2 wires for the speed control module, and removed the control module. Six screws and 2 wire terminal screws.
Did you find this story helpful?
Thank you for voting!
Router would start and stop but would not run long enough to use
1: Removed the top cover plate. (2 screws).
2: Removed the side cover plate. (2 screws).
3: Loosed two screws holding the connection wires. (Small slotted screwdriver.)
4: Lifted out the defective module.
5: Threaded in the new module.
6: Connected the wires.
7: Dropped in the new module.
8: Repla
... Read moreced the cover plates.
9: Tested the router.
Notes: There is one purple wire and one gray wire. Note where they are before disconnecting. Note which side the speed adjuster is on the module before removing.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10169293
Manufacturer Part Number: 326297-01
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 326297-01 DeWALT Module,Electron")
_WW_1.gif "Part Location Diagram of 326297-01 DeWALT Module,Electron")
