This part is an OEM from Makita. The depth guide is made for use with several circular saw devices. This component is fastened to the base assembly, allowing the operator to measure the saw for project material depth. This item is sold individually. A wrench is often necessary for making the replacement. Please refer to the manual and diagrams for additional instructions.
Remove blade.
Remove blade guard stop(located behind blade) philips screw.
Loosen 2.5mm hex set screw at base plate.
Remove stop ring on depth adjustment knob.
Loosen depth adjustment knob until free.
Withdraw bolt through depth guide, noting washer positions and guide orientation.
Replaced damaged dept
... Read moreh guide.
Reverse steps.
Some adjustment required for depth guide knob upon reinstallation. Simply tighten to your preferred tightness on the adjustment knob without installing the stop ring and orient to the correct position, then finish with the stop ring.
Remove guard stop screw
Move guard out of the way
Remove slip washer and unscrew main bolt holding the depth gauge to the saw
Use small allen wrench and remove the base plate off the depth gauge
Remove bent depth gauge and install the new one in reverse steps
Fiddle with placing the release level to it tighte
... Read morens and releases at the proper tensions
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
