The purpose of this cord is to supply power from a standard U.S. outlet to an electric power tool. It is an authentic manufacturer sourced replacement part that is designed for use with Milwaukee power tools. Over time the cord may crack exposing wires, if this happens it should be replaced immediately. This durable rubber insulated power supply cord is sold individually, please note the cord protector is sold separately.
Troubleshooting
This part works with the following brands:
Milwaukee
This part works with the following products:
Miter Saw
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Disassembled the handle to remove the old cord. I had a little difficulty sliding the motor housing cover back on while trying to separate the motor bushings. I had to remove the motor housing end cap cover to tilt bushings to the side in order to slide cover back on.
Removed the left side of the handle part of the case.
Removed the switch from the housing.
Removed the cord ends from the switch.
Crimped eyelets onto the ends of the new cord.
Installed the new cord onto the switch.
Reinstalled the switch into the housing and routed the cord through the housing and out the c
... Read moreord holder.
Reinstalled the left side of the handle and tested the saw.
Works Great.
Read less
Did you find this story helpful?
Thank you for voting!
Power cord was cracking and the cord protection had broken off
removed all the screws from handle front half
removed the strain relief inside the handle
unplugged the power cord from switch and hook up mew cord
then reattached all the screws on the handle and ws ready to do more cutting
1. Disassembled the handle housing by taking out the screws.
2 Removed the old cord, being sure to note the cord routing.
3 Attached crimp-on terminals to the bare wires of the new cord.
4. Reattached the cord protector
5. Routed the new cord,
6. Installed the handle on the saw with the screws.
7. Visu
... Read moreally checked everything over.
8.. Powered up the saw to complete the repair.
Removed the screws from the handle.
Separated the handle.
Removed the old power cord.
Installed the new power cord.
Reassembled the handle.
Tested the miter saw no problems.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10122783
Manufacturer Part Number: 22-64-1422
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 22-64-1422 Milwaukee Power Supply Cord W/plug")
_WW_1.gif "Part Location Diagram of 22-64-1422 Milwaukee Power Supply Cord W/plug")
