Part Location Diagram of 16-30-0700 Milwaukee Armature
See part 21 in the diagram
( Grid squares measure 1x1 inch )

Armature 16-30-0700

Manufactured by:
Milwaukee
ERP Number:
ERP10121487
Part Number:
16-30-0700
Original Equipment Manufacturer ?
$97.45
In Stock
Delivers in 3-5 Business Days!

A Bit Difficult 

30 - 60 mins 

(1 rated repair) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

It is a genuine replacement item that is supplied directly from the original equipment manufacturer for use with Milwaukee sawzalls. The armature is the center component is an electric motor which is at the heart of the tool, over time it may wear out and begin to fail eventually requiring a replacement. If the tool is continuously overloaded then the copper windings may become extremely hot and melt the insulation. Please note this high-quality part is sold individually.

Troubleshooting

This part works with the following brands:
  • Milwaukee
This part works with the following products:
  • Saw
  • Reciprocating Saw

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

30 - 60 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

The field burnt up and damaged the motor housing, brushes, and remote electronic assembly.

Joel from Hiram, Ohio

1 person found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Remove the entire Motor Housing. Then remove the white wires for the armature brush assemblies and save them. I really started new. I took the new motor housing and installed the new field. Then I removed the Fan from the old armature and installed it on the New Armature. You also need to remove the old bearing and reuse it. Tap everythin g together with a piece of scrap wood and a small hammer. Replace the brush wires and reassemble everything. You will need to solder the black wire from the remote electronic assembly to the switch. I also used a wire nut on the solder joint. Take plenty of pictures with your phone as a reference. This helps with placing the wires in the proper slots. Total time was probably 2 and 1/2 hours with cleaning. Take your time. The rubber boot was the hardest part to take off.
Did you find this story helpful?
Thank you for voting!
  • 1

Model Cross Reference

This part works with the following models:
ERP Number: ERP10121487
Manufacturer Part Number: 16-30-0700
Brand Model Number Description
Milwaukee 6520-21 Reciprocating Saw - 12 Amp Orbital Sawzall Recip Saw
Milwaukee 6523-21 Reciprocating Saw - Sawzall
Milwaukee 6523-55 Saw - Milwaukee 6523-55-(A75a) Parts
Milwaukee 6523-69 Saw - Milwaukee 6523-69-(0306) Parts
Milwaukee 6536-21 Reciprocating Saw - 1-1/4" Stroke Sawzall
Milwaukee 6537-55 Saw - Milwaukee 6537-55-(Sspe 1300 Sx) Parts