Plate And Pad Kit For 6020-21 14-67-0280

replaced with new pad

Took off old pad and replaced with new pad. Had to replace all parts that came in kit which included the brackets below the pad. Had to study a while before I found out how to take off old brackets. Once I realized how to do it, it was simple.

It was easy, just 4 Allen screws I removed.
The pad came off being loose when the screws were removed.
The base was next, it was a tight fit to remove, rocking back and forth while pulling and cam off.
One problem I had was, the parts kit did not have the replacement gasket for the base to sander.
So I had to be ... Read more careful and remove the old one.
Reinstalled the gasket to new base.
I used an air hose to blow out all the sanding debris in sander .
Mounted base to sander and making sure the plastic mounting legs line up into base.
Set new pad with its aluminum plate onto the base.
Installed the 4 allen screws.
Added sand paper and works great......

Removed the four screws from the old pad and plate
Installed the new parts with the screws

remove old padded plate and adjoining parts with torx screwdriver from Milwaukee palm sander. line up new parts and plate and reinstall screws.
Install 1/4 sheet of sandpaper and start using
good as new

Milwaukee does not include felt replacement ring in kit. Necessary to carefully peel out old felt ( with double face tape) in order to reuse. Strange because directions say not to use old parts!