It is a genuine item that is supplied directly from the original equipment manufacturer for use with Craftsman table saws. This is an identical replacement for a missing or a faulty slide that helps to create a smooth sliding motion for the miter table top. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable plastic and is sold individually.
There are four slides to adjust the orientation of the sliding table. Slides are adjusted individually with eccentric screws holding the individual slide set. Each slide set has two mating plastic pieces. These are identified slide \"A\" (top) and \"B\"(bottom) on the parts diagram of the table saw. Each part has a different part number.
... Read more They are 66184401 and 66184501 respectively. The two sub-parts are connected with the eccentric screw of the slide. You are selling only the bottom piece. I had to use a file to configure the the extra piece I ordered to look like the top piece. It is not pretty but it works.
Read less
Did you find this story helpful?
Thank you for voting!
Missing set screw, broken quick stop, and discovery of incorrectly installed SS shims were replaced or corrected.
One set screw was missing from the Miter table cam latches over the last 14 years of use by the original owner (he and I used this saw beginning in 2004 when he purchased it for a house renovation project). The second owner was my son who upgraded in 2015 after replacing the drive belts. I bought it back from my son and have used it sin
... Read morece as a traveling construction quality saw. The parts I have bought have been to keep it serviceable as long as possible. Too many critical parts are no longer available. I will part this out unless I can find someone who has the same feeling. The Ryobi BT3000 is a good quality construction saw, used in conjunction with my 50yo Delta Cabinet saw.
1 Slide B broke, rendering the mitre table useless. It has been replaced and re adjusted.
The quick stop mitre stop broke many years ago.
What was significant and corrected was the mis installation of the SS shims that caused the Blade raise system to lock up. That required 3 total hours of investigation and correction without replacement parts, but the SS shims (Fig 59, parts 86 had to removed, hammered, and correctly reinstalled.
Read less
Did you find this story helpful?
Thank you for voting!
I DROPPED THE SLIDE PLATFORM AND THE LITTLE SLIDE PIECES BROKE.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
✖
[{"position":0,"name":"Home","title":"Home","url":"/"},{"position":1,"name":"Drawer or Glides","title":"Drawer or Glides","url":"/parts/power-tool/table-saw/drawers-and-glides/"},{"position":2,"name":"661845001","title":"661845001","url":""}]
