It is a genuine item that is supplied directly from the original equipment manufacturer for use with Campbell Hausfeld air compressors. A check valve is an important safety feature that will release excess pressure from the tank. If the valve is damaged or missing it should be replaced to ensure your equipment functions safe and properly. One durable metal check valve assembly is included. Refer to the owner\\\'s manual and the diagrams for your model for the correct installation of the new part. You will need a wrench to secure and remove this check valve. Make sure to drain the air from the tank before starting the repair.
After checking start capacitor and finding it was good I removed check valve and found it had came apart inside. This caused air pressure to go back into the pump causing motor to over load and pop breaker. New check valve fixed problem.
Removed the old Check Valve and Ferrule. Cleaned the threads with steel wool. Wrapped one end of the threads with Teflon tape and put it all back together and tightened all parts. Note: the check valve is installed very tight. You may need a pipe to go over your wrench for leverage to remove it..
Removed lines going to valve with adjustable wrench gently pried hose line with screwdriver off. Put Teflon tape on fittings on new valve reapplied valve to tank and lines back to valve.
Did you find this story helpful?
Thank you for voting!
Bad check valve replaced, exhaust tube replace and foot installed.
Remove tubes from old check valve, Then replace the new valve. Install small tube back onto check valve. Replaced bent exhaust tube. If you are careful you can use the same compression nut and ferrule. Pressed rubber foot into hole in foot base.
Did you find this story helpful?
Thank you for voting!
Air compressor kept bleeding air when tank full and pressure level reached.
Did research and learned problem not caused by control valve but more likely the check valve. Removing old check valve very easy although very tight quarters on Kobalt 30 Gallon vertical compressor. New check valve fit perfectly, however, the body of the new check valve was shorter than the old check valve so the aluminum tube that conne
... Read morects from the pump to the check valve was about 3/4\" too short. Found a piece of aluminum 1/2\" pipe in the shop, bent it, replaced the two 1/2\" compression sleeves and installed. In all, took about 1 hour and everything works perfectly.
Read less
Did you find this story helpful?
Thank you for voting!
Compressor tank check valve wore out (leaking air)
1. Disconnected the air line from the pump to the check valve.
2. Removed the old check valve from the tank inlet.
3. Replaced the check valve with the new unit.
4. Reconnected the air line from the pump.
Tube wrenches are the best tools for this repair however, a combination wrench can be used, just go eas
... Read morey not to round off or flatten the compression fitting nuts. I do not recommend adjustable wrenches, pliers, or other slip joint, or locking style pliers. Get a good solid wrench that fits correctly!
1. Remove the two lines from the check valve
2. Remove the bad check valve
3. Clean the threads on the line fittings
4. Install plumbers threat tape on all threads
5. Install the check valve in the compressor tank
6. Install the two lines from the compressor to the check valve
7. Plug in and test for le
... Read moreaks
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
