Gasket-float Chamber 11060-7018

The mower had been in storage for 2+ years. I put in fresh gas and a battery, but although it cranked fine it wouldnÆt even pop, let alone start. I had to remove the muffler to get the carb out. Carb disassembly was straightforward. I removed the float hinge pin and float, and needle, then used carb cleaner and compressed air to clean the ... Read more float bowl, needle seat, and jets, and every orifice/pathway I could see.
Reinstalled the float with new needle, new gasket, and reassembled with no issues.
Reinstalled the carb, and the muffler, using new exhaust gaskets.
It still wouldnÆt start! So, since it seemed like it wasnÆt getting fuel, I removed the fuel shutoff solenoid, and found it badly gummed up. Carb cleaner to the rescue! I cleaned the solenoid and reinstalled it. Started up immediately and it runs like new!

removed carb removed float chamber cleaned replaced carb fired up motor

removed carb from engine, gaskets ripped from face and after cleaning the float gasket was warped. cleaned all jets and re installed parts once the arrived

Had problems finding parts needed until I found ereplacementparts.com where found what I needed thanks for your help I removed the carburetor cleaned it removed old gaskets replaced with New, took pictures of carburetor and linkage which was a big help