Part Location Diagram of 697854 Briggs and Stratton Switch-rocker
See part A-347 in the diagram
( Grid squares measure 1x1 inch )

Switch-rocker 697854

Manufactured by:
Briggs and Stratton
ERP Number:
ERP9066462
Part Number:
697854
Original Equipment Manufacturer ?
$22.02
In Stock
Delivers in 3-5 Business Days!

Easy 

15 - 30 mins 

(3 rated repairs) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

This is a genuine manufacturer-approved replacement rocker switch which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is the part of the unit handling on/off operations, over time it may wear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body component is sold individually.

Troubleshooting

This part works with the following brands:
  • Briggs and Stratton
  • Simplicity
This part works with the following products:
  • Engine
Part# 697854 replaces these:
693623, 696213,

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(3 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

On/Off Sw. failed.

Timothy from Enfield, Connecticut

2 of 2 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Parts Used:
697854
Used a small screwdriver to press in the plastic side tabs in to remove the switch. Put the wire in the same place from the old switch to the new switch, then pressed the new switch back in.
Did you find this story helpful?
Thank you for voting!

On/off switch was bad , fuel shut off valve and tank grommet was leaking fuel

Vic from FROSTPROOF, Florida

1 person found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Socket set
Parts Used:
G080270, G078299, 697854
Removed housing that the on off switch was in depressed the ends of the switch with flat head screwdriver and pushed it out.
Put wires on new switch in proper order and snaplocked back into place.
Tilted unit gas tank to put fuel away from the valve end , removed gas line, pulled and wiggled the gas valve out of grommet.
Pried grommet out of tank with small pry bar, pressed new grommet , pressed valve into grommet
Did you find this story helpful?
Thank you for voting!

Short in on/off switch

Claude from Ocala, Florida

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Socket set
Parts Used:
697854
Removed plastic cover removed old switch replaced new switch replaced plastic cover
Did you find this story helpful?
Thank you for voting!
  • 1