This is a genuine Ridgid replacement part that has been sourced from the original manufacturer to be used with pressure washers. The pressure switch attaches to the regulator and is used to turn the motor on and off based on the pre-set level of air pressure. This item is sold as an individual replacement part.
Troubleshooting
This part works with the following brands:
Ridgid
This part works with the following products:
Compressor
★
Customer Part Reviews
?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
5 stars
1
4 stars
0
3 stars
0
2 stars
0
1 star
0
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
The right part!
I was sceptical of getting a switch for my compressor especially since the manufacture indicated it was no long available. It fit perfectly and performed well.
dennis
Guest - November 5, 2019
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Remove the parts that are not included with the new pressure switch,and set aside. Open cover on switch and make a wiring diagram of where the wire are connected. Remove wires, then remove old pressure switch. Install new pressure switch and connect the wires per the wiring diagram. Install the other parts on the new pressure switch. Rem
... Read moreove the old relief valve and replace it with the new one.
Read less
Did you find this story helpful?
Thank you for voting!
Old pressure switch blew out the internal rubber gasket. Sounds simple to replace just the gasket, but I could not find one. Air compressor would run fine but had and air leak from the rubber gasket,
Jeff from Onalaska, Wisconsin
1 personfound this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Socket set, Wrench (Adjustable), Wrench set
Removed the old switch, which included using wrenches to disconnect gauges and pressure lines and to unscrew from the tank. Had to undo the plug and motor wiring to reconnect them to the new switch. I then added Teflon tape to all the threads that needed to be attached to the new switch and connected them. One pressure line had a compress
... Read moreion fitting that I reused on the new switch. It was easier than trying to put in a new line. Everything worked great and I was able to finish a texturing job that required a compressor.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
