This is an authentic replacement part sourced directly from the manufacturer. The hall sensor is commonly found in DeLonghi coffeemakers. This part is used to send electrical signals from the flowmeter to allow the machine to monitor the water usage. This item is available as an individual replacement part.
Troubleshooting
This part works with the following brands:
DeLonghi
This part works with the following products:
Coffee Maker
Espresso Machine
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Ask our experts a question on this part and we'll respond as soon as we can.
Something went wrong. Please try again later.
Your Question Has Been Submitted!
Our experts will send you an email as soon as your question has been answered.
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
15 - 30 mins
(3 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
The brew unit would not go into the home position. Brew unit would go all the way up and stay after machine was turned on. Unable to brew shots or steam.
The hall sensor is located on the bottom of the transmission assembly. You have to remove the transmission to replace it as far as I could tell. Remove the brew unit, remove the hex screw located behind. This is the screw that holds the transmission assembly in place. To remove the brew unit on from the back I did find it necessary to rem
... Read moreove the screws mounting the water boiler so it could move out of the way. Once removed, observe the hall sensor board on bottom. Replace and route wires to the control board.
The connection mentioned in the parts was the connector on the output side of the water solenoid valve. Mine leaked causing the damage to the hall sensor.
Read less
Did you find this story helpful?
Thank you for voting!
The machine did not sense the correct position of the brew group, stuck in top position.
The rear panel unscrews first, then the side panels slide back and off for access. The Hall sensor is located at the left front area. It is easiest to loosen the drive by unscrewing from the front, taking the two screws out from the center of the drive holder. There are two small screws that hold the small sensor board. Loosen and replace
... Read more with the new board.. then follow the cable back to the location where it plugs into the board. Reposition the brew drive, and replace the screws. Replace the side panels, then the back panel. The machine then goes through itÆs movements flawlessly.
Read less
Did you find this story helpful?
Thank you for voting!
Delonghi Magnifica\'s group would go up and get stuck
It took a while to troubleshoot the issue.
I was not able to test my old Hall Sensor to make sure it was broken, so I made a guess and purchased the replacement.
Obviously, the guess was derived from numerous observations and comparisons on what was available online.
Instructions were also taken several videos.
... Read moreShipment cost was a little high for such a small part.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
