This switch is specially designed to stop the engine when you move it to the stop position/setting. It is an authentic replacement item that is supplied from original equipment manufacturer for use with Husqvarna chainsaws. Includes one (1) switch per order. To replace this stop switch you will need a screwdriver. • Make sure to disconnect spark plug and drain fuel • Remove screws from the housing • Separate housing pieces • Disconnect wires from the old switch • Secure new stop switch in place • Reconnect the wires • Reassemble and test the new switch
WAS NOT A DROP IN REPLACEMENT FOR MY HUSKY RANCHER MODEL 61 as listed -
had to DRILL A HOLE IN THE SAW - and put a mouting screw into the frame - TO PROVIDE A GROUND-
Did you find this story helpful?
Thank you for voting!
The fuel line and filter were completely junk....I decided to go through the entire saw
1. I completely stripped the saw, by taking all the parts apart.
2. Cleaned all of the parts in solvent and used compressed air where necessary
3. Dismantled Walbro carburetor to inspect and clean
4. Reassembled carburetor installed new spark plug
5. Swapped out parts and installed the chain brake on the new clutc
... Read moreh cover
6. Fine tuned the carburetor after warm up.
Runs like a champ!
Read less
Did you find this story helpful?
Thank you for voting!
Ignition hot lead was broken and grounding out and stop switch ground strap broken in two.
1- Removed top cover
2- Disconnect spark plug boot
3- Remove recoil starter cover and plastic flywheel/coil module cover
4- Remove hot lead wire from ignition module to coil
5- Re-route new hot lead wire and re-connect
6- Remove stop switch and ground strap screw then ground wire from module to stop switch
... Read morer />7- Install new stop switch with ground strap screw and re-route new ground wire from module to swatch
8-Re-install flywheel/ coil module cover and recoil starter cover
9- Remover spark plug, install boot and ground plug to engine. Pull recoil starter and check plug for spark and switch operation (on =spark; off= no spark)
10- Reinstall spark plug and boot. Re-install top cover
Read less
Did you find this story helpful?
Thank you for voting!
muffler gskt. missing, replace screws vibrated loose during use.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_9.gif "Part Location Diagram of 503717901 Husqvarna Stop Switch")
_WW_9.gif "Part Location Diagram of 503717901 Husqvarna Stop Switch")
