Maytag Dryer Wheels and Rollers

This drum support roller includes one drum roller and two bearings. Most dryers use two drum rollers, and it is recommended to change both at once.

This genuine OEM dryer drum support roller is designed to hold the drum in place while allowing it to rotate smoothly and quietly during operation. Built for durability and reliable performance, it helps reduce noise and ensures consistent tumbling. Ideal for replacing worn or damaged rollers, it resolves issues such as squeaking, rumbling, or poor drum movement, helping restore efficient and depe...

This kit includes two rear drum support rollers, four tri-rings, and one palnut. It is recommended that you replace both rollers at once.

This blower wheel comes with a metallic hub clamp to hold it firmly in place.

This idler pulley wheel is white and made of plastic. It is two inches in diameter and comes with a center bearing.

This single drum support roller is used for square ported model clothes dryers. It has a metallic bearing in its center.

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

This two inch wide idler pulley wheel is beige in color and is made of plastic. This pulley wheel comes with its own metallic bearing in its center.

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

This shaft is for the front with right hand thread. Sold individually.

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.

Part may differ in appearance, but functions same as original part.

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

This arm is what attaches to the idler pulley wheel. The grommet no longer comes with the part as it has been updated by the manufacturer.

This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.

This kit includes 2 glides (left and right), 2 pads with adhesive backing and 1 support brace.

Sold individually.

This blower wheel is suitable for some clothes dryers of the 10 and earlier series. Manufactured to fit a 1/2 inch motor shaft, this blower wheel is 3-1/8 inches deep. The diameter of the wheel is 7-1/8 inches, and the spring clamp is not included.

This drum support roller bracket and shaft assembly is two inches long. It is made of metal.