Kenmore Dryer Seals and Gaskets

This is a duct felt seal for a dryer. The duct felt seal allows the front-load dryer drum to glide smoothly on the front panel. Your dryer will not function properly if the drum felt seal is compromised. Disconnect power to the dryer before completing this repair. You will need to remove the front of the dryer to gain access to the felt seal. This felt seal may differ in appearance from your origi...

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

This seals Includes adhesive. This part helps seal the drum to prevent hot air from escaping.

This seal comes with the adhesive backing.

This part helps to keep the dryer running as quietly as possible.

This seal comes with the adhesive backing.

This part seals between the blower housing and the blower housing cover.

This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Includes high temperature adhesive.

This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-ring is made of rubber, and can occasionally wear down and break. If you notice that your dryer drum bearing is worn while you’re replacing the O-ring, you should consider replacing it as well. This pr...

The upper felt seal for your dryer is attached to the top edge of the drum support area, and is held there by a high temperature adhesive. It creates a seal where the dryer door opens and closes, so that heat remains in the dryer while it tumbles. If your old upper felt seal is coming apart, you notice that hot air is leaking out the dryer door, or your clothes are taking too long to dry, you may ...

This is 39 inches long.

Adhesive is sold separately.

This part is the replacement upper front felt seal for your dryer. It is made of felt and is approximately 17 inches long and 1 inch wide. The felt seal allows the drum to glide smoothly on the front panel. If your dryer is noisy, will not tumble, or leaves marks on your clothes after the drying cycle, you may need to replace the upper front felt seal. This part is sold individually, so if you do ...

This is an OEM dryer felt seals and includes adhesive.