Kenmore Dryer Fuses

It is used in dryers.

The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

This thermal fuse limiter, with a limit of 220 degrees Fahrenheit, is manufactured for both gas and electric clothes dryers. Once the internal temperature of the dryer reaches 220 degrees, the heating element cuts out.

This part attaches to the exhaust duct of your clothes dryer.

This thermal fuse is a safety component designed to protect the appliance by interrupting electrical flow if excessive temperatures are detected. It helps prevent overheating and potential damage to internal components. When the fuse blows, replacing it can restore operation after the underlying heat issue has been addressed.

This dryer thermal fuse is a critical safety component designed to protect the appliance from overheating. It automatically shuts off power to the motor or heating system if excessive temperatures are detected, helping prevent damage or potential fire hazards. Once the fuse is triggered, it cannot be reset and must be replaced. A faulty thermal fuse may cause the dryer not to start, run without he...

The thermal cut off fuse will disrupt the power flow to the drive motor when the dryer gets too hot. If your dryer will not heat properly, or will not heat at all the issue could be with a faulty or damaged thermal cut off fuse. Before you replace the faulty cut off fuse, make sure you disconnect the power from your dryer.

This part is a one time use thermal fuse cannot be re-set and must be replaced when continuity between the pins is no longer present.

This service replacement component is designed to substitute a superseded part and restore proper function and fit. It ensures continued performance when the original component is discontinued or updated.

This heating element is a replacement component designed to generate heat for cooking or warming functions. It is commonly replaced when heating becomes uneven or stops entirely. Proper appliance fit should be confirmed prior to installation.