Part Location Diagram of 628885-00 DeWALT Id Label
See part 29 in the diagram
( Grid squares measure 1x1 inch )

Id Label 628885-00

Manufactured by:
DeWALT
ERP Number:
ERP10182709
Part Number:
628885-00
Original Equipment Manufacturer ?
  Works with your model  D28131!
$5.95
In Stock
Delivers in 3-5 Business Days!

Easy 

30 - 60 mins 

(2 rated repairs) ?
  Works with your model   D28131!

Product Description

?

This is an authentic DeWalt replacement part, sourced from the original manufacturer for use with angle grinders. The special identification label is used to improve the look of the angle grinder. This label is available as an individual replacement, please see model diagram for associative parts.

Troubleshooting

This part works with the following brands:
  • DeWALT
This part works with the following products:
  • Angle Grinder
  • Grinder

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

30 - 60 mins 

(2 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Brushes was old and needed replaced

Jonathan from Hot Springs , Arkansas

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Not much to say just took it apart and replaced the parts
Did you find this story helpful?
Thank you for voting!

Mainly repaired for cosmetic reason, case had labels that had worn off

Domingo from Baytown, Texas

0 of 1 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Replacing the case is very straight forward, remove the four screws that hold gear case, remove all screws that hold halves of rear case assembly, remove armature assembly and field after disconnecting leads, remove the brush holders and brushes after disconnecting them, remove brush terminals and reinstall on new case, install the little flat coil springs on new case, this is the only part that was a little difficult for me since they are small and can only go in one way since the sit in case that secures them is closed on one side, then it is a simple matter to reverse disassembly procedure, grinder now looks as new!
Did you find this story helpful?
Thank you for voting!
  • 1