We sell only genuine Max ® parts.
Enter Your Model Number
This genuine manufacturer-sourced part is specially designed for Max nailers. It is an important component which provides a tight seal between connected components. Unfortunately, over time it will wear out and it may begin to crack eventually requiring a replacement. To ensure the correct repair procedure, refer to the appropriate diagrams for your model. Note, this high-quality O-ring is made of durable rubber material and is sold as an individual item. A screwdriver will be needed to take apart and reassemble the tool when performing this repair.
This part is an OEM from the MAX manufacturer. The rubber washer 7 is compatible with many nailer devices. This item often secures the step pin in the feed pawl. It is recommended to refer to specific manual and diagrams for repair instruction. The rubber washer 7 is sold individually. A hex key and a wrench are helpful in making the replacement.
This is an original Max replacement part manufactured for use with pneumatic nailers. The gasket is used to seal the cylinder cap and frame. It is recommended to replace worn or damaged seals to prevent air leaks after servicing the nailer. This cylinder cap seal is sold individually.
This replacement bumper is a genuine manufacturer sourced item used with Max roofing coil nailers. The purpose of the bumper is to prevent piston from hitting the bottom of the cylinder and damaging it. Because it gets so much abuse over time it may crack and fall apart eventually requiring replacement. This bumper is made from durable high quality plastic material and it is sold individually.
It is an OEM item which is made for Max stick nailers. This component provides an air-tight seal for the cylinder cap. Over time the material will wear out and it may begin to crack eventually requiring a replacement to prevent air leaks. To ensure the correct installation of the new seal, refer to the specific diagrams of your model. Note, it is made of durable material and is sold as an individual component. You will need an Allen wrench to remove and resecure the cylinder cap hardware in order to perform this repair.